Merit M-8S Power Sequencer is the perfect low-cost AC power solution for any rack mount system. Install an M-8S in your rack, and the eight outlets in the rear panel will power up in sequence and protect all your equipment up to a 15-amp load.
Prevents excessive inrush currents.
Noise filtering to reduce radio frequency and electromagnetic interference.
Ensures equipment stays safe.
Eight rear panel outlets and one front panel convenience panel outlet.
15 amp rating, with circuit breaker.
Front panel indicator LEDs for Outlet Banks, Protection OK and Power Status.
Rear outlets have been spaced to accommodate even the bulkiest of wall warts and adapters.
Maximum Output Current:
15 amps, 120 VAC (Thermal breaker)
14AWGx3, 10 feet, black, fixed, NEMA 5-15P plug
• Convenience Outlet (Front Panel) 1 Un-switched NEMA 15-5R • Rear Panel Outlets: 2 Un-switched NEMA 5-15R (1 duplex), • 6 Sequenced NEMA 5-15R (3 duplexes, each controlled by separate relay)
Standard level AC Surge Protection:
Merit Class (sacrificial)
Spike Protection Mode:
Line to neutral, zero ground leakage
Max Continuous Operating Voltage:
Max Clamp Voltage:
500 Volts Peak
Peak Impulse Current:
Energy Rating (2 X 820Î¼S):
Standard level Pi LCR Filter
>26dB, 100 Khz to 1 MHz
Operating Temperature Range:
5C (40F) to 40C (105F) degrees
<90% rH (Relative Humidity)
Front panel, Sequence (ON, OFF)
Thermal Circuit Breaker:
Front panel, push to reset
Front Panel Indicators:
Delay 1, Delay 2, Delay 3, Power, Protection OK
Rear Panel DIP Switches:
12V Mode On/Off, GND Mode On, Momentary/Maintained
Rear panel, time calibration fine tune delay adjust
+5-30VDC In, 12VDC (12mA) Out
Phoenix type 4-Pin Connector with Screw terminals; +12V, STAT, REM, GND (Class 2 Wiring)